DigiTrak Falcon F5+ - User Manual

To Next Page

- 1 -

digital-control.com

DigiTrak Falcon® transmitters

The Falcon family of transmitters come in wideband, single-band, and Sub-K®

rebar with a variety of features, power modes, and depth/data ranges. The

battery and power mode you choose for your transmitter will affect the depth

and data range available for your job.

Find your Falcon transmitter product ID

The product ID of your transmitter (Tx) is on the etching. Use the product ID to

look up your transmitter's available power modes, battery life, depth, and data

ranges in the charts in this quick start guide.

1. Etching

2. Colored label

3. IRPort

Choose the best battery for the job

Use only real DCI SuperCell™ and LiR batteries for High power mode and 19-

and 24-inch Standard power. You can use 2 C-cell alkaline batteries for 15-inch

Low and Standard (Std) power, but the SuperCell is best for extreme conditions

and longer battery life. 8-inch transmitters only use Li CR123 and 6-inch

transmitters only use Li AAor Alkaline AA. Always install a fully charged battery.

Rechargeable Falcon Transmitter Adapter (FTA) for Lithium Ion

batteries

The Falcon Transmitter Adapter (FTA) requires a single 21700 Lithium

Rechargeable (LiR) battery with built-in protection and is specifically designed for

and supplied with every Falcon 15/19/24-inch transmitters with a blue tube.

Recommended Manufacturer Part Number

Klarus 21GT-50

Fenix ARB-L21-5000

Acebeam IMR217000NP-510A

Only use 21700 batteries of diameter 21-22 mm and length 75.5 mm ± 1 mm.

Other batteries may not fit the FTAor survive the rigors of HDD.

Need help?

Do you have a question about the DigiTrak Falcon F5+ and is the answer not in the manual?

DigiTrak Falcon F5+ Specifications

General