Digitrax 3 Series - Page 3

5.0 Decoder Programming .........................................28
5.1 What are Configuration Variables (CVs)? ......................... 28
5.2 Service Mode and Ops Mode Programming Methods ..... 28
5.3 Programming Modes ........................................................... 28
5.4 DCC Outputs: Programming & Layout Operation ...........29
5.5 Reading & Writing CVs .......................................................29
6.0 CVs-Configuration Variables ..............................30
7.0 Basic Decoder Setup CVs .................................... 34
7.1 Decoder Addresses .............................................................34
7.1.1 Decoder 2 Digit Address: CV01 ..................................35
7.1.2 Decoder 4 Digit Address: CV17 & CV18 ....................35
7.2 Configuration Register: CV29 ............................................36
7.2.1 Characteristics Controlled by CV29 ...........................36
7.2.2 Determining CV Value To Program Into CV29 ...........37
8.0 LocoMotion CVs ....................................................40
8.1 Acceleration and Deceleration Rates ............................... 40
8.1.1 Acceleration Rate: CV03 ..............................................40
8.1.2 Deceleration Rate: CV04 ..............................................40
8.2 Throttle Response Curves & Loadable Speed Tables ....41
8.2.1 Simple 3 Step Speed Table .......................................42
8.2.2 V-Start: CV02 ................................................................42
8.2.3 V-Max: CV05 .................................................................. 42
8.2.4 V-Mid: CV06 ..................................................................42
8.2.5 Simple 3 Step Speed Table Examples .......................43
8.3 High Res 28 Step Loadable Speed Tables CV65-95 .........43
8.4 CV54 Torque Compensation, Switching Speed & Decoder
Lock Disable ...............................................................................46
8.5 Scaleable Speed Stabilization (Back EMF) .......................47
8.6 Advanced Consist Address CV19 .....................................50
8.7 CV61 Transponding & LED/Lamp Algorithm Selector ....50
8.7.1 Transponding Feed Back From Decoders ..................50
8.7.2 LED/Lamp Algorithm Selector ....................................51
8.7.3 CV61 Values: Transponding & Lighting Algorithm ..51
8.8 CV09 SuperSonic (Quiet Operation) ................................52
9.0 Function CVs .........................................................52
9.1 Digitrax Light Effects: CV49-CV52 & CV113-CV116.........52
9.2 Setting Up FX
3
Effects On Function Outputs ...................52
9.3 Commonly Used FX
3
Effects On Function Outputs ........53
9.3.1 Simple On/Off Function ..............................................54
9.3.2 Forward Ditch Lights Operating on F2 ......................54
9.3.3 Rear Ditch Lights Operating on F3 & F4 ................... 55
9.3.4 Mars Lights On F1 ........................................................56
9.3.5 Rotary Beacon on F1 ...................................................56