What to do if the Digitroll SEED MASTER Plus 8.6 Control Systems monitor works but the “power out” LED doesn't light or blinks?
If the “power out” LED doesn't light or blinks, disconnect modules from the monitor. Systematically disconnect modules starting from the monitor side to check for a cable pinch. By doing the same disconnection process, you can find the defective unit that caused a short circuit, such as a defected seed module.
What to do if the Digitroll Control Systems monitor functions, the ‘power out’ light is on, but test sensor signals are partially or totally missing?
If the monitor functions with the ‘power out’ light on, but test sensor signals are partially or totally missing, it could be due to several reasons. First, check and reset row detection where necessary, as the issue might be caused by accidentally switching off row detection, leading to some rows missing from the screen. Push the TEST button and note the number of the last detected seed module if you suspect a hurt cable, connector, or defected module. If battery leads are probably hurt or the output side of module 4 or module 5 is defected, disconnect and bridge the suspected defect module.
Why does the Digitroll SEED MASTER Plus 8.6 Control Systems monitor indicate irregular seed drops when the seeder is stopped?
The monitor may indicate irregular seed drops when the seeder is stopped because the sensitivity was set too high. To resolve this, adjust a higher time limit to reduce sensitivity.
How to fix no seed detection at a properly working Digitroll Control Systems seeder when test finds seed modules and no dust is indicated?
If there is no seed detection at a properly working seeder, and the test finds seed modules with no dust indicated, it could be due to small-sized seeds at a low rate of seeding or a defected module. Adjust to a small seed size and a higher missing seed time interval. Also, check the module by blinking the LED with a long stick inserted inside.
General| Brand | Digitroll |
|---|---|
| Model | SEED MASTER Plus 8.6 Series |
| Category | Control Systems |
| Language | English |
To Next Page
