Digitus DA-30501 - Getting Started; Charging the Battery of DA-30501; TX Mode; Switching On;Off the Transmitter

3

Getting started
1. Charging the battery of DA-30501
DA-30501 comes with a built-in rechargeable battery, prior to using it, it is
recommended to charge the battery fully for the first time.
When DA-30501 is low power, red LED flashes. Please recharge the battery of
DA-30501.
Connect the charger to a standard power outlet and the charger plug to the
charging jack of DA-30501. Red LED is on while charging. It takes about 3 hours
to charge the battery fully. When charging is completed, red LED will be off.
Note: Please don’t attempt to take out battery from DA-30501, in case of
damaging DA-30501.
Warning:
1) The battery is recyclable.
2) Do not dispose of the battery in fire, as it may cause explosion.
 TX Mode
Selecting mode: Please turn the TX/RX switch to TX mode before switching on
DA-30501.
Note: TX or RX mode cannot be changed after switching on DA-30501.
1. Switching on/off the transmitter
Function Operation LED indicato
r
Switching on
transmitter
Press button for 3-4
seconds
Blue LED is on for
1second
Switching off
transmitter
Press button for 3-4
seconds
Red LED is on for 1
second and then off
2. Pairing with a Bluetooth device
After the transmitter connecting to a Bluetooth stereo receiver, you can enjoy
music wirelessly. Before pairing, please make sure your Bluetooth stereo receiver
supports Bluetooth A2DP profile.
The pairing steps are as follows:
1) Make sure the transmitter is off, otherwise switch it off;
2) Keep the transmitter and your Bluetooth stereo receiver within 1 meter;