Digitus DA-30501 - Auto-Off; Clearing Pairing List; LED Indicator; RX Mode

5
3) Can be connected
In addition, when the transmitter is in standby mode and doesn’t connect to any
devices, it can accept the connecting request sent by the receiver that has
already been paired with the transmitter before.
4. Auto-off
The transmitter will automatically switch off if no devices can be connected within
5 minutes.
5. Clearing pairing list
Make sure the transmitter is off, press and hold button for about 10 seconds,
and don’t release it until red LED is on for 1 second and then blue LED is on for 1
second.
6. LED indicator
LED indicato
r
Status of the transmitte
r
Blue LED flashes continuously Pairing mode
Blue LED flashes once every 1 second Standby mode and not
connected to a device
Blue LED flashes twice every 4 seconds Connected to a device
Red LED flashes Low power
 RX Mode
Selecting mode: Please turn the TX/RX switch to RX mode before switching on
DA-30501.
Note: TX or RX mode cannot be changed after switching on DA-30501.
1. Switching on/off the receiver
Function Operation LED indicato
r
Switching on
receiver
Press button for 3-4
seconds
Blue LED is on for 1
second
Switching off
receiver
Press button for 3-4
seconds
Red LED is on for 1
second and then off