Digitus DA-70200-1 User Manual

DA-70200-1 • User's Manual
USB 2.0 TO IDE & SATA Cable
1. Characteristics
 Support SATA spread-spectrum transmitter
 Support SATA II Asynchronous Signal Recovery (Hot Plug) feature
 Compliance with USB 2.0 (Hi-Speed USB) electrical specification
 Compliance with USB Mass Storage Class Bulk-Only Transport Specification
 Support 480Mbps High Speed (HS) and 12Mbps Full Speed USB operation
 Support ATA/ATAPI-7
 Support ATA/ATAPI Ultra DMA Mode
 Support ATA/ATAPI PACKET command feature set
 Support ATA/ATAPI LBA48 addressing mode
 Support dual LUN (Logic Unit Number) for USB to ATA/ATAPI
 Support Windows 7/8/8.1, Vista, Windows XP, Windows 2000, Windows ME, 98SE
 Need driver installation under Windows 98SE
Product introduction
1. USB 2.0 A male
2. IDE port for 2.5’’ IDE hard drive
3. Power socket for 5V input power adapter
4. SATA port for 2.5’’/3.5’’ SATA hard drive
5. IDE Port for 3.5’’ IDE hard drive
6. Power Indicator
7. Active: The light will keep flashing when it is detecting the 2.5’’/3.5’’ SATA /IDE hard drive or during the
data transferring.
⑥ Power Indicator
⑦ Active

Digitus DA-70200-1 Specifications

General

Category	Adapter
Model	DA-70200-1
Interface	USB 3.0
Ethernet Speed	10/100/1000 Mbps
Data transfer rate	Up to 5 Gbps
Chipset	Realtek RTL8153
Compatibility	Windows, macOS
Operating temperature	0°C to 50°C
Type	USB 3.0 to Gigabit Ethernet
Connector(s)	USB 3.0, RJ-45
Power supply	Bus-powered via USB