Digitus DA-90430 - Step 3

9
Step 3
Attach Tabletop to Beam
Note: Place the beam in the middle of the plank and leave a proper distance on each side, then
fix it. If the width of the beam is not appropriate, you can refer to step 1 to adjust the width
1. The distance between the two sides should not be than 200mm
2. H (Nut Wrench)
Install the beam assembly (step 2) on the tabletop, use a 5x5 (with cross)
allen key (H) to screw in the screws (G) and the screws (B) and tighten them.