You can synchronize the PC selection, by using the following two-step Hot Key
sequence. To send commands to the Combo KVM Switch, press the [Scroll] key
twice (Step 1), then press key [1] or [2] or [3] or [4] and [Enter] (step 2) to assign
the PC to a particular PC. (If you press key [1] or [2] or [3] or [4] on the
number pad, the keyboard, mouse & video will also be switched
synchronously. If you do not assign the specific PC number from 1~4, and
just press [Enter] after the twice scroll lock pressing, then the KVM will
switch to next PC. If you press the left arrow key then the KVM will switch
to the forward PC, the right arrow key will switch to next PC.
5.2.2 Auto-Scan Function
Hot Key:
[Scroll] → [Scroll] → [S] → [Enter] to BEGIN.
Any key to STOP.
You can activate the Auto-Scan function by using the following two-step Hot Key
sequence. To send commands to the Combo KVM Switch, press the [Scroll] key
twice (Step 1), then press [S] and then press [Enter] (Step 2). When you press the
Auto-Scan hot key sequence, the Combo KVM Switch alternates between the two or
four PCs and displays them on the monitor.
Each PC is displayed in a time interval from 5 ~ 250 seconds (The interval is
adjustable) before switching to the next. When you press any key on the keyboard,
the Auto-Scan will stop and the monitor screen will jump back to the original PC.
During the Auto-Scan mode, the KVM will ignore the mouse operation, so if you
move mouse you will not see the cursor move on the screen.
Adjustable scan time interval setting ( 5 ~ 250 sec. )
Hot-key: Pressing the <Scroll >, <Scroll > then <S> and <5 ~250 > <Enter>
To Next Page
Loading...
Need help?
General
