How to fix Digitus Switch keyboard not responding?
If your keyboard isn't responding with the Digitus Switch, try the following: * Re-install the keyboard by unplugging it from the Console Port and plugging it back in. * Re-install the KVM Switch by shutting down the PCs, unplugging the cables, waiting five seconds, and plugging them back in. * If in Auto Scan Mode, press the [Esc] key to exit. * Try using a different keyboard.
What to do if Digitus DC OC-12 mouse has no response?
If your mouse isn't responding with the Digitus Switch, try the following steps: 1. Re-install the mouse by unplugging it from the Console Port and plugging it back in. 2. Re-install the KVM Switch by shutting down the PCs, unplugging the cables, waiting five seconds, and plugging them back in. 3. Ensure the mouse is set to PS/2 mode. 4. Try using a different mouse. 5. If using a special mouse, install the manufacturer's driver to enable full functionality with the KVM Switch.
Why is my Digitus Switch mouse out of control?
If the mouse is out of control when using the Digitus Switch, it may be due to an inefficient mouse. Try using a different, superior mouse and plug it back in.
Why are the LEDs on my Digitus Switch green or red when PCs are off?
When the LEDs show green or red flashing lights while PCs are turned off when using the Digitus Switch, this is a normal state. It indicates that the keyboard and/or mouse are receiving power from the PC internal setting.
Displays the status of PC connection and selection via LEDs.
Allows selection of PCs directly from the keyboard using Hot Key navigation.
Troubleshooting steps for keyboard non-responsiveness, including re-installation and alternative keyboards.
Troubleshooting steps for mouse non-responsiveness, including re-installation and PS/2 mode check.
Addressing mouse control issues by trying a superior mouse and ensuring proper operation start.
Addresses video issues, noting high resolution/bandwidth limits and supported resolutions up to 1920x1440.
Explains that flashing LEDs when PCs are off is normal, indicating keyboard/mouse power.
Instructions on how to select a PC by double-pressing the Ctrl key.
How to enter Command Mode by pressing Num Lock twice for PC selection and function key usage.
Activating Auto Scan Mode by pressing Scroll Lock twice to monitor PCs sequentially.
General| Basic switching RJ-45 Ethernet ports quantity | 12 |
|---|---|
| Store-and-forward | Yes |
| Power supply included | Yes |
| Interface | RJ-45 |
| Form Factor | Desktop |
| MAC address table | 8000 entries |
| Mounting | Wall |
To Next Page
