D. Choose the desired printer. The desired printer must be the
Windows printer (this is a logical printer) that matches the
printer attached on the MFP server (this is a physical printer).
Then click the “Apply” button.
E. Then, the printer will be marked as an “Auto-Connected
Printer” in red.
F. Then try to issue a print job to the desired printer using the
usual steps.
II. NetUSB Scanning
A. In the Control Center, click the MFP server that has the desired
MFP attached.
B. Click the desired MFP.
C. Click the “Network Scanner” button. The following window
will appear.
10
To Next Page
Loading...
