# If you use SMB on Windows 98 SE/ME, you must login to your
Windows 98 SE/ME using the same user name as in server’s User
Account.
9. Perform Open, Paste, Remove or Copy the files to the shared
folders.
- Using FTP Method for Sharing Storages
1. Open Microsoft IE
2. In Web Address List, type command: “ftp://server’s server
name “ or “ftp:// server’s IP address”. If you have changed the
default FTP port : 21, you have to add the new port number in
the tail of the command as “ftp://server’s server name:ftp port”
or “ftp://IP address of server: ftp port”
3. The shared folders will be listed in IE.
4. If you set Enable Server Authentication in FTP server protocol
settings you have to type user name and password to login to
the server; if you set Allow Anonymous Login, you can use the
user name “anonymous” to login with Read-only permission. If
you clear server authentication, you do not need username or
password to login to the server. You can add user name and
password in User Account box by MFP Control Center or
server’s Web page.
5. Perform Open, Paste, Remove or Copy the files to the shared
folders.
⑩
. The NetUSB Technology
“NetUSB” technology allows you to use USB printers or USB MFPs
and USB storage devices as if they were connected directly to your PC
although they are actually connected to the Digitus MFP server. The
“connect” operation is a software operation that simulates an actual
USB device plug-in. That is to say, when you do a “connect” operation
in the Control Center, PC can then detect a USB device’s plug-in,
although actually you do not plug in any USB device. Similarly, the
“disconnect” operation is a software operation that simulates the
disconnection of the USB device. Once the connect operation is
successful, the operations to use that USB device are just the same as if
the USB device is directly connected to the PC.
8
To Next Page
Loading...
