Insert Micro SD Card
The data originally saved in the micro SD card (if any) will be removed after inserting it to the camera.
The camera doesn’t support hot-swapping. Please insert or remove the micro SD card with power disconnected.
Please follow the directions in the below graphic to insert Micro SD card properly:
CAMERA CONFIGURATION
For advanced configuration of your DIGITUS camera with
DIGITUS NVR, please refer to below for the connection:
Step1: Connect PC to the HUB connected to your camera(s) with RJ45 network cable.
Step2: Install the “IPScan.exe” from the CD on your computer and use this utility to find the IP address of the camera.
Step3: After searching, set your PC in the same network segment as the specific camera you want to access, such as
“192.168.30.xxx” (xxx could be 0~255) in our example
Step4: Note down the IP address and port number of the camera you want to access, such as “192.168.30.1” and “88” in our example.
Step5: Open Internet Explorer on the PC, and enter the IP address and port number in the URL column to access the camera. The
format is http://ipaddress:portnum, such as http://192.168.30.1:88 in our example.
To Previous Page
Loading...
Need help?
General
