Why is the Digitus DN-170041 UPS beeping twice every second?
The Digitus UPS might be beeping twice every second because it is overloaded. Try removing some of the devices connected to the UPS output. If the devices are fed directly by the electrical network via the Bypass, remove excess loads, shut down the UPS, and then restart it.
What to do if the Digitus UPS shows fault code 43?
If the Digitus UPS displays fault code 43, it means the UPS shut down automatically due to an overload at the output. To resolve this, remove some of the devices connected to the UPS output and then restart the UPS.
What to do if the Digitus DN-170041 shows fault code 14?
If the Digitus UPS shows fault code 14, the UPS shut down automatically because a short circuit occurred on the UPS output. Check the output wiring and the devices connected to see if any are causing a short circuit.
Why is my Digitus UPS battery backup time so short?
The battery backup time on your Digitus UPS might be shorter than expected because the batteries are not fully charged. Charge the batteries for at least 5 hours and then check the capacity.
How to fix Digitus UPS when there is no indication and alarm?
If there is no indication and alarm on your Digitus UPS, even when the main power is normal, check if the input power cord is firmly connected to the mains. Also, ensure that the AC input power cord is correctly plugged into the AC input.
General| Model | DN-170041 |
|---|---|
| Type | Line Interactive |
| Nominal Input Voltage | 230 V |
| Communication Interface | USB |
| Operating Temperature | 0°C to 40°C |
| Form factor | Tower |
| Output Voltage | 230 V |
| Output Frequency | 50/60 Hz |
| Transfer Time | 2-6 ms |
| Battery Type | Lead-Acid |
| Battery | 12V/7Ah |
| Typical Recharge Time | 6 hours to 90% capacity |
| Humidity | 5% to 95% (non-condensing) |
| Input Voltage Range | 162 - 290 V |
| Outlets | 4 x IEC C13 |
Guidelines for safely transporting the UPS system in its original packaging.
Pre-installation steps including acclimation and environmental checks for the UPS.
Instructions and warnings for connecting the UPS system to power and loads.
Safety precautions and guidelines for operating the UPS system.
Warnings for maintenance, service, and handling UPS faults due to hazardous voltages.
Identification and description of ports and connectors on the rear panel of the UPS.
Procedures for physically installing the UPS unit, including rack-mount and tower options.
Steps for connecting the UPS input, output, and communication ports.
Instructions for safely replacing the internal UPS batteries without shutting down the unit.
Guides the assembly of optional external battery kits for extended UPS runtime.
Details the functions of the ON/MUTE, SELECT, and OFF/ENTER buttons on the UPS.
Explanation of the UPS LCD display indicators for status, load, and battery information.
Describes the different audible alarm sounds and their corresponding UPS events.
A reference for understanding abbreviations displayed on the UPS LCD screen.
Instructions for configuring UPS parameters such as output voltage, frequency, and ECO modes.
Explains various UPS operating modes like Online, ECO, AECO, Battery, and Bypass.
Lists fault codes, icons, and events for diagnosing UPS issues.
Details warning indicators, their icons, and associated alarms for UPS status.
Information on UPS operation, battery lifespan, and replacement recommendations.
To Next Page
