9
7.2.1 Install to the desktop
You can place this product directly on a clean, solid, grounded desk.
7.2.2 Wall mounted
You can also place this product on a clean, solid vertical wall. The
installation process is as follows:
1. Fix the mounting brackets with screws
2. Insert the capsules into the holes on the wall. (The capsules are not
included in the package.)
3. Insert the screw into the hole of the dowel. Please use screws with
a diameter of 3-5 mm. Fix the network switch with the screws.
8. Connect the cable
1) Before installation, please turn off the power of each signal
source and the device to be displayed. The installation of the
power supply may cause damage to the transmission equipment.
2) Use the network cable to connect the network camera and
the 1-4 Electrical port of the device respectively;
3) Connecting the optical fiber interface of the device with the
optical fiber interface of the uplink equipment using the optical
fiber line.
4) To connect the power supply equipment.
5) Check whether the installation is correct, equipment damage, to
ensure that all connections are reliable, to the system power.
6) To confirm whether the network equipment, power supply,
work is normal.
To Next Page
Loading...
