Technical parameters:
1. Standard Protocol:
IEEE802.3 10 Base-T standard
IEEE 802.3u 100Base-TX/FX standard
IEEE 802.3z 1000Base-TX/FX standard
2. Connector: one UTP RJ-45connector,one SC/ST connector
3. Operation mode: full duplex mode or half duplex mode
4. Environmental temperature: 0℃-60 ℃
5. Relative humidity: 5%-90%
6. TP cable: Cat5 UTP cable
7. Transfer fiber:
multi-mode: 50/125, 62.5/125 or 100/140μm
single mode:: 8.3/125, 8.7/125, 9/125 or 10/125μm
8. Max. 2M buffer memory built in chip
9. Automatic identification of MDI/MDI-X cross line
10. High-performance 1.4Gbps memory bandwidth.
Cautions:
1. This product is suitable for indoor application.
2. Put on the dust cover of fiber interface when not used.
3. It is forbidden to stare at the TX fiber-transfer end with naked eyes.
4. Single optical fiber transceiver must be used in pair (See the attachment description in delivery).
Trouble shooting:
1. Device is not matched. Please select the corresponding network device according to the transfer rate of
the product (10Mbps or 100Mbps) when connected to other network devices (network card, hub, switch).
2. Line loss is excessive during the fiber wiring. Excessive loss in connector plug-in and fiber soldering
welding, and excessive intermediate nodes may cause excessive loss rate or abnormal operation.
To Previous Page
Loading...
Need help?
General
