Why Digitus Fan unit does not start?
If your Digitus Fan unit doesn't start, first ensure the unit is powered on by checking the input power supply apparatus and verifying the wiring is solid. If the unit still doesn't start, check the phase sequence power and wiring, as an incorrect power sequence could be the cause.
What to do if Digitus DN-97330 has compressor overload?
If you're experiencing a compressor overload with your Digitus Fan, it could be due to several reasons. It may be caused by thermal overload, in which case you should check the air conditioning refrigerated space insulation and sealing. It could also be due to excessive refrigerant in the system, so you may need to discharge some refrigerant. Other potential causes include a fault within the compressor itself (axle or motor coil insulation), voltage supply instability, or loose compressor wiring. Ensure to re-tighten the compressor terminal.
What to do if Digitus DN-97330 Fan shows high pressure protection alarm?
If your Digitus Fan is experiencing high-pressure protection alarm, it could be due to a faulty pressure protection switch, which would need replacing. Alternatively, the expansion valve might be too loose, requiring you to adjust its opening degree appropriately.
What causes Fan overload in Digitus DN-97330?
If your Digitus Fan is experiencing Fan overload, several factors could be responsible. Check the filter installation and ensure that the correct windshield is selected. Also, verify the input power to ensure the voltage is not too low. Lastly, inspect the fan motor windings to confirm they are normal.
What to do if Digitus DN-97330 Fan shows low- pressure protection alarm?
If your Digitus Fan is showing a low-pressure protection alarm, the issue might stem from a faulty low voltage protection switch, which requires replacement. Another potential cause is that the expansion valve is too small, necessitating an adjustment to increase its opening degree.
To Next Page
General