10
Interior: smooth out of the wind inside the device, not within 300mm from
tuyere is blocked, the indoor side heat well, a good seal. Access to rear line
arrangement.
Outdoor: smooth out of the wind, far away from people stay. Outdoor wind
direction should not be opposite to the monsoon. If direct sunlight, should be
done protection. Prevent high temperature and humidity, dust, air enters the
device acid. Installation position and stay close to the obstacle distance of at
least 500mm. Ground clearance of not less than50mm.
Installation Guidelines
Equipment must be in good condition. Sealed from the outside.
3.2. Unpacking Inspection
Out of the box before check the packaging for damage, if there is damage,
please contact the carrier.
Carefully remove the packaging and check whether there are internal devices
scratches, impact, if any, please contact the carrier.
The packing list an inventory of accessories are complete, if not complete,
please contact the supplier.
- Remove the front and back packaging must ensure that the device
remains upright, not tilted or tipped over.
3.3. Device Installation
3.3.1. Mechanical Installation
1. The sealing inlet airflow port and outlet airflow port.
2. At the top of the cabinet, openings are made according to the size
and position of the air inlet and outlet in the air-conditioning room.
The air conditioner is installed at the top of the cabinet to be fixed.
Fasten with fasteners such as screws and nuts.
3. Drain connected to the drain assembly in the apparatus, the drain
connected to the drain drain assembly, with hose clamps firmly fixed,
and the other end to a suitable drain through the drain. If using
outdoors, you cannot take drain assembly and drainage pipes,
drainage equipment directly at the outfall.
To Next Page
Loading...