Digitus DN-97330 - Envrionmental Requirements; 3 Installation and Commissioning; Installation Preparation

9
2.3. Envrionmental Requirements
Operating Envrionment
Table 2-2 Products Operating Environment
Project
Indoor side
Room outer side
Temperature
-10 °C ~ 55 °C
-20 °C ~ 45 °C
Humidity
20 % to 80 %
-
Altitude
Altitude <1 000 m
Greater than 1 000 m
Derating about 6 % / one thousand meters
Power supply
Single-phase or three-phase 380V 220 ~ 240VFrequency
50Hz ± 2HzOr 60Hz± 2H
Storage Envrionment
Table 2-3 Product storage environments
Project
Claim
Surroundings
A clean (no dust), well-ventilated
Temperature
-40 °C ~ +60 °C
Humidity
5 % RH ~ 95 % RH non-condensing
Duration
A total of not more than six months, more than six months
to be re-calibrated performance
3. Installation and Commissioning
3.1. Installation Preparation
Tools to prepare
Wrench, socket wrench, Phillips screwdriver, slotted screwdriver, diagonal
pliers, needle nose pliers, the word ladder, tape measure, flashlight, marker,
truck. Insulated gloves, wire strippers, insulating tape, crimping pliers, clamp.
Material preparation
Drain line, power supply cable.
Site Preparation
Mounting plate: air-conditioning sheet metal plate or rack load capacity is
enough to bear weight without deformation apparatus, distortion.