TEMPERATURE TREND ILLUSTRATION
TEMPERATURE & HUMIDITY
OUTDOOR TEMPERATURE ALERT SET：
At normal time displaying mode, hold pressing ‘DOWN’ button for seconds to enter
temperature alert setting. The figure to be set will be flashing by 1HZ. The setting
order is temperature alert function (ON/OFF) ---high temperature alert values setting
---low temperature alert values setting --- exit.
(Default high temperature alert values : 70℃/158℉; Default low temperature alert
values: -50℃/-58℉.)
Press ‘UP’ button to get one step increased on the settings, and hold for 2 seconds will
get 8 steps increased per second.
Press ‘DOWN’ button to get one step decreased on the settings, hold for 2 seconds will
get 8 steps decreased per second.
Press ‘SET’ button to confirm the setting.
If no operation within 30 seconds, it will exit automatically and keep current settings.
1. Once the batteries are installed, the weather station will begin searching for a signal.
Within 3 minutes, the weather station will receive the RF signal and display current
weather status.
2. Press “DOWN” key to switch ℃/℉.
3. Press and release the “UP” key repeatedly, the current in/out temperature and hum-
idity will alternate between the MAX/MIN temperature recordings and the current
values.
4. In MAX/MIN temperature display mode, hold pressing “UP” key to reset indoor and
outdoor MIN/MAX data to current values at the same time.
Temperature
Trend Indicators
Illustration
The unit displays when power on.
When detecting 1
℃ down from previous temperature,
or the temperature goes down by 1
℃ (or more) within
an hour, the unit displays this.
When detecting 1
℃ up from previous temperature,
or the temperature goes up by 1
℃(or more) within
an hour, the unit displays this.
To Next Page
Loading...
Need help?
General
