Dimension One Spas Dynamic Massage Sequencer - Water System Issues and Solutions

2002 Dimension One Spas Export Owner’s Manual
Water System
Symptom
Problem Corrective Action
Pulsating jets
Water level too low Fill with water to 1” (2.54 cm) to 2” (5.08 cm) above bottom of the tile line
1. Jets are turned off 1. Turn jets on by turning jet face clockwise
2. Diverter Valve
turned
2. Turn the Diverter Valve clockwise or counter clockwise
3. Dirty Filter 3. Clean Filter
4. Air lock 4. Loosen pump union to allow air to bleed
No Jet Action,
or action is
poor
5. Gate valve closed 5. Open gate valve
The “Check
Water
Level…..”
scrolling
message and /or
3 flashing
L.E.D.s appear
on the display.
1. Possible sensor
errors
1. Check water level
2. Clean filter
3. If problem continues:
a. Turn off
power
b. Restart the
spa
4. If problem persists:
a. Call your dealer for service
33