To pair the product to the Wireless remote:
1. The product, once installed and turned on, will emit a beep and begin to broadcast
a signal to be paired with the Wireless remote.
2. Wake the remote by briefl y holding the ENTER
button.
Once awake the remote will then immediately
search for the product. This is indicated by the
rotating loading graphic and fl ashing connectivity
icon on the remote followed by the pairing
sequence.
NOTE:
The remote will attempt to pair with the fi rst product it fi nds. Please
ensure that no other products are broadcasting within the vicinity to
prevent pairing to the incorrect product.
3. The remote will search for devices for 1 minute. If no product can be found, the
remote will display ‘NO PROD’ before returning to a sleep state. If this happens,
please repeat steps 1 and 2.
4. If connection is successful the product will emit a second beep and the remote
screen will show a solid connectivity icon for 4 seconds then revert to the home
screen.
NOTE:
After initial pairing the Time and Date must be set before the remote
will revert to the home screen.
Solid icon
Remote Pairing Instructions
NOTE:
If no remote pairs within 2 minutes, the product will stop broadcasting.
fl ashing icon
loading
graphic
12
To Next Page
Loading...
Need help?
General
