time is ready to be set. Time is set in 1 hour increments, and can be
set up to 12 hours. Press the ‘+/-’ buttons to set the desired time.
8. Press the timer/temperature set button twice to set the temperature.
The numbers will flash on the LED display when the temperature is
ready to be set. The temperature can be set between 5-35°C. Press
the ‘+/-’ buttons to set the desired time.
9. Press the SWING button to activate oscillation mode. Press again to
deactivate this mode.
10. Press the ON/OFF button to turn the unit off. It will take approx. 10
seconds for the fan to turn off and enter standby mode.
CLEANING AND MAINTENANCE
Cleaning
Pushing the unit up against a wall or operating it in close proximity to long
window drapes will also impair the unit’s air flow and efficiency.
1. Disconnect the appliance from the main supply and allow to
completely cool down.
2. Use a soft cloth to wipe any dust from the heaters surface. If the
surface is too dirty, use warm soapy water and a soft cloth to clean.
Do not use solvents or abrasive products.
3. If storing the heater, ensure it has completely cooled down, is dry
and packed away in a cool dry place.
To Next Page
Loading...
Need help?
General
