Dimplex DHOP1341 - Heater Installation

6 www.dimplex.com
Heater Installation
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of re, electric shock or injury to
persons.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of re, electric
shock and injury to persons.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of re,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: To reduce the risk
of re, do not store or use gaso-
line or other ammable vapors or
liquids in the vicinity of the heater.
CAUTION: To reduce the risk
of electric shock, this appliance
has a three pronged plug (Figure
1). This plug will t in a grounded
outlet/inlet only one way. If
the plug does not t, contact a
qualied electrician to install the
proper outlet. Do not change the
plug in any way.
!
NOTE: A 15 Amp, 120 Volt cir-
cuit is required. A dedicated circuit
Figure 1
5.0 ft (153 cm)
10.0 ft (305 cm)
Figure 2