REMOTE CONTROL INITIALIZATION
This procedure is required every time there is a loss of power to the remote control in the fireplace (i.e.
power failure, breaker tripped, main power switch is turned off).
1. Ensure that power is supplied through main service panel.
2. Locate manual controls (refer to your product’s Owner’s Manual).
3. Activate main power switch, (“
_
” position) Red Indicator Light 1 will flash.
4. Press and hold the Manual Selection Switch for five (5) seconds (“
_
” position) UNTIL the second
Red Indicator Light flashes.
5. Press the ON button on the remote control transmitter.
This will synchronize the remote control transmitter and receiver.
TROUBLESHOOTING
If the remote control is not responding;
1. Check if the product’s plug is fully inserted into the outlet.
2. Replace the Remote Control’s battery (see BATTERY REPLACEMENT).
3. Check the electrical panel to see if the circuit breaker is on. If you need to continuously reset the
circuit breaker, you may be overloading the circuit. Try another outlet or circuit.
4. Re-initialize the Remote Control see REMOTE CONTROL INITIALIZATION.
If the remote turns on or off by itself or if the remote control is interfering with the operation of other
remote control devices (TV, VCR, garage doors etc.):
A replacement hand held transmitter may be required with a different frequency code. Contact your
dealer with your current remote frequency code for replacement.
NOTE: When replacing the remote control handheld the fireplace will need to be re-initialized.
To Previous Page
Loading...
