OPERATING INSTRUCTIONS
- 3 -
Please use both hands to
carefully empty the water tank.
● DEFROST
● Operation
1) Place the product in an upright position onaflat, steady,
stable, heat-resistant surface. Make sure there is nothing
flammable or heat sensitive within 100 cm .
Operating the product in any other position could be
hazardous.
2) Insert the plug into a suitable wall socket. The dehumidifier
is suitable for operation on an electricity supply of the
same voltage as that shown on its rating label.
3) Make sure the water tank is correctly located. (After
switching on the machine for the first time, if the "Bucket
Full" lamp illuminates, just pull out the water tank, check
the "float" lever is able to move freely, then ret
urn the water
tank to the correct position.)
● When Bucket Full Lamp Is On
When the water tank is full the machine will stop and the "Bucket Full" light
will illuminate. The water tank should be carefully removed from the
machine by sliding it outwards from the front of the machine and it should be
emptied. When the empty tank is replaced properly into the machine, the
machine will start up and run normally.
When the machine is operated at low temperatures (less than 12°C) the surface of
the evaporator may accumulatealayer of frost which would reduce the efficiency
of the machine. When this happens the machine will go into periodic defrost mode.
The defrost symbol on
the LCD display will come on. The machine will operate
in temperatures down to 5 . The time taken to defrost may vary. If the machine
freezes up, it should be turned off at the power supply and re-started. If the room
temperature remains below 5 the machine should be switched off.
°C.
°C
To Next Page
Loading...
Need help?
General
