Fitting the Batteries:
The remote requires two AA batteries. These are supplied with the product con-
tained in the bag along with the instructions and remote.
To fit the batteries:
1. On the rear of the remote, remove the
battery cover by pushing the catch
downwards and pulling outwards in one
motion.
2. It should be possible to completely remove
the battery cover to reveal the battery
cavity.
3. Carefully insert the new batteries, ensuring
the polarity is correct. Ensure the ‘+’ and
‘-‘ signs on the batteries match the signs
marked inside the battery cavity.
4. Once the batteries are in place, replace the cover, ensuring the clip has engaged fully.
Once the batteries have been successfully fitted the remote control will immediately
start scanning for a product to control. At this stage it is necessary to complete the
pairing process, see Remote Pairing Instructions.
Remote control cradle:
The remote control is supplied with a wall
mounting cradle. If desired, mount the
cradle in a suitable location. The cradle can
be mounted using suitable screws and the
appropriate wall fixing solution, not supplied.
Mark and drill the wall accordingly to mount
the remote control cradle. The remote
control can also be fixed to the cradle using
the bottom fixing screw. The use of this
screw is optional, particularly if the remote
will be used as a portable device.
NOTE:
If the remote cradle is not initially required please store in a suitable
location in case of future use. The bottom fixing screw should also be
stored with the cradle
11
To Next Page
Loading...
Need help?
General
