28
Before commencing cleaning, isolate the heater from the electrical supply and allow it to cool. The outside can be
cleaned by wiping it over with a soft dry cloth. Do not use abrasive cleaning powders or furniture polish, as this
can damage the surface finish. To release the heater from the wall bracket for cleaning or redecoration, depress the
latch on both brackets (See Fig. 2) and hinge forward.
Cleaning
RF Module Installation
1. Unhinge the heater from the wall using the clips shown in Fig. 2 (page 7) and locate the battery module,
indicated in Fig. 5; 1.
2. Slide the catch and pull module from the controls (See Fig 5; 2/3).
3. Replace the tray with the radio freqency module
4. Power the product on and make sure that the RF comms are enabled. Comms settings will be located in the
settings menu (see page 22)
During the initial operation, some odour may be noticed due to the newness of materials used in manufacture. This
is normal and will disappear after a short period of use. It is however advisable to keep the room well ventilated
Important
WARNING - ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER.
To Next Page
Loading...
