- 5 -
3. Ensure the heater is stable before removing the
screws which hold the grille panel in position.
Set the grille to one side.
4. Remove the two screws located towards to
bottom of either end of the heater, which retain the
heater sides.
Push the left hand and right hand sides vertically
upwards to release each side from its securing
points.
5. Remove the two screws securing the front panel,
located at the upper sides of the heater, and swing
the upper edge of the front panel forwards and
unhook it from along the heater base.
Fig. 3
Fig. 4
Fig. 5
To Next Page
Loading...
