To Next PageTo Next Page
Need help?Do you have a question about the Dimplex SP29 and is the answer not in the manual?
General| Model | SP29 |
|---|---|
| Type | Electric Fireplace |
| Width | 29 inches |
| Voltage | 120V |
| Heating Area | up to 400 sq ft |
| Remote Control | Yes |
| Thermostat | Yes |
| Heat Output | 1500W |
| BTU Output | 5100 BTU |
| Flame Technology/Effect | LED Flame Effect |
Heater must not be covered to prevent overheating, indicated by a warning symbol.
Appliance must be earthed, used with correct AC supply voltage, and switched on only after installation.
Unpack carefully, retain packaging, and note remote control features like flame illumination.
Fix heater securely to wall at minimum 300mm height, observing distances and drilling guides.
Appliance can be recessed; ensure secure fixing with appropriate devices for wall material.
Construct a suitable support structure for recess mounting, including electrical provisions.
Use standby and auto/man switches to control the heater manually, with flame effect indication.
Turn standby on and switch to 'AUTO' for remote control; allow time for receiver response.
Disconnect power, remove front panel carefully, and replace 60W E14 SES bulbs.
Use a soft, clean duster for general cleaning; use a soft cloth for the glass viewing screen.
