OPERATOR’S MANUAL with Maintenance Information
Operating Instructions
25
Emergency Stop
Push in the red Emergency Stop button to the
off position at the ground controls or the
platform controls to stop all machine functions.
Repair any function that operates when either
red Emergency Stop button is pushed in.
Emergency Lowering
1 Pull the emergency lowering knob to lower
the platform.
Operation from Ground
1 Turn the key switch to ground control.
2 Pull out both ground and platform red
Emergency Stop buttons to the on
position.
3 Be sure the battery pack is connected
before operating the machine.
To Position Platform
1 Move the up/down switch according to the
markings on the control panel.
Drive and steer functions are not available
from the ground controls.
Operation from Platform
1 Turn the key switch to platform control.
2 Pull out the ground and platform red
Emergency Stop buttons to the on
position.
3 Be sure the battery pack is connected
before operating the machine.
To Position Platform
1 Press the lift function select button.
2 Press and hold the function enable switch
on the control handle.
3 Move the control handle according to the
markings on the control panel.
To Steer
1 Press the drive function select button.
2 Press and hold the function enable switch
on the control handle.
3 Turn the steer wheels with the thumb
rocker switch located on the top of the
control handle.
To Drive
1 Press the drive function select button.
2 Press and hold the function enable switch
on the control handle.
3 Increase speed: Slowly move the control
handle off center.
Decrease speed: Slowly move the control
handle toward center.
Stop: Return the control handle to center or
release the function enable switch.
Use the color-coded direction arrows on the
platform controls and on the platform to
identify the direction the machine will travel.
Machine travel speed is restricted when the
platform is raised.
Battery condition will affect machine
performance. Machine drive speed and
function speed will drop when the battery level
indicator is flashing.
To select drive speed
The drive controls can operate in two different
drive speed modes. When the drive speed
button light is on, slow drive speed mode is
active. When the button light is off, fast drive
speed mode is active.
Press the drive speed button to select the
desired drive speed.
Note：When the platform is elevated, the drive
To Next Page
Loading...