OPERATOR’S MANUAL with Maintenance Information
Transport and Lifting Instructions
34
Observe and Obey:
√ Common sense and planning must be
applied to control the movement of the
machine when lifting it with a crane or
forklift.
√ Only qualified aerial lift operators should
move the machine on or off the truck.
√ The transport vehicle must be parked on a
level surface.
√ The transport vehicle must be secured to
prevent rolling while the machine is being
loaded.
√ Be sure the vehicle capacity, loading
surfaces and chains or straps are sufficient
to withstand the machine weight. See the
serial label for the machine weight.
√ The machine must be on a level surface or
secured before releasing the brakes.
√ Only qualified forklift operators should lift
the machine with a forklift.
√ Be sure the crane capacity, loading
surfaces and straps or lines are sufficient to
withstand the machine weight. See the
serial plate for the machine weight.
Brake Release Operation
1 Chock the wheels to prevent the machine
from rolling.
2 Pull out the red Emergency Stop button on
both the ground and platform controls to
the on position.
3 Press the brake release switch to on
position.
4 Press and hold lift switch to “down”
position in ground control, meanwhile turn
on the key switch to the "Ground" position.
The brake will be released after Alarm
alerts.
5 If you want to close the brake release, just
turn off the key switch in “ground” position.
6 Push the red Emergency stop button on
both the ground and platform controls to
the off position.
The machine must be towed, do not exceed
4km/h.
To Next Page
Loading...