OPERATOR’S MANUAL with Maintenance Information
Transport and Lifting Instructions
35
Securing to Truck or Trailer for
Transit
Always chock the machine wheels in
preparation for transport.
Retract and secure the extension deck(s).
Turn the key switch to the off position and
remove the key before transporting.
Inspect the entire machine for loose or
unsecured items.
Use the tie-down points on the chassis for
anchoring down to the transport surface.
Use a minimum of four chains or straps.
Use chains or straps of ample load capacity.
Lifting the Machine with a
Forklift
Be sure the extension deck, controls and
component trays are secure. Remove all loose
items on the machine.
Fully lower the platform. The platform must
remain lowered during all loading and
transport procedures.
Use the forklift pockets located on both sides
of the driving wheels.
Position the forklift forks in position with the
forklift pockets.
Drive forward to the full extent of the forks.
Raise the machine 6 in / 15 cm and then tilt the
forks back slightly to keep the machine secure.
Be sure the machine is level when lowering
the forks.
Lifting the machine from the
side can result in component damage.
To Next Page
Loading...