DINGLI AMWP8-1200 - Page 43

OPERATOR’S MANUAL with Maintenance Information
Maintenance
38
Maintenance Inspection Report
Model
Serial number
Date
Hour meter
Machine owner
Inspected by (print)
Inspector signature
Inspector title
Inspector company
Instructions
• Make copies of this report to use for each
inspection.
• Select the appropriate checklist(s) for the
type of inspection to be performed.
□
Daily or 8 hours
Inspection:
A
□
Quarterly or 250 hours
Inspection:
A+ B
□
Semi-annually or 500
hours Inspection:
A+B+C
□
Annually or 1000 hours
Inspection:
A+B+C+D
• Place a check in the appropriate box after
each inspection procedure is completed.
• Use the step-by-step procedures in this
section to learn how to perform these
inspections.
• If any inspection receives an “N”, tag and
remove the machine from service, repair and
re-inspect it. After repair, place a check in the
“R’ box.
Legend
Y = yes, acceptable
N = no, remove from service
R = repaired
Checklist A
Y
N
R
A-1 Inspect the manuals and
decals
A-2 Pre-operation inspection
A-3 Function tests
Perform after 40 hours:
A-4 30 day service
Perform every 100 hours:
A-5 Grease steer yokes
Checklist B
Y
N
R
B-1 Batteries
B-2 Electrical wiring
B-3 Tires and wheels
B-4 Emergency stop
B-5 Lifting Chains
B-6 Clean and Lubricate the
Columns
B-7 Test the up limit switches
B-8 Key switch
B-9 Horn
B-10 Drive brakes
B-11 Drive speed - stowed
B-12 Drive speed - raised
B-13 Hydraulic oil analysis
B-14 Tank venting system
B-15 wire ropes system
Checklist C
Y
N
R
C-1 Platform overload
C-2 Breather cap - models with
optional oil
Checklist D
Y
N
R
D-1 Hydraulic oil