OPERATOR’S MANUAL with Maintenance Information
Maintenance
44
Component damage hazard.
The platform railings can be damaged if they
are used to lift the platform. Do not attach the
lifting strap to the platform railings.
6 Inspect for a liberal coating of dielectric
grease in the following locations:
• Between the ECU and platform controls
• All wire harness connectors tilt sensor
7 Open the cover.
8 Inspect the battery tray for burnt, chafed
and pinched cables.
9 Close the battery tray cover.
10 Remove the strap from the platform.
11 Lower the platform to the stowed position
and turn the machine off.
B-3
Inspect the Tires and Wheels
(including castle nut torque)
DINGLI requires that this procedure be
performed every 250 hours or quarterly,
whichever comes first.
Maintaining the tires and wheels in good
condition is essential to safe operation and
good performance. Tire and/or wheel failure
could result in a machine tip-over. Component
damage may also result if problems are not
discovered and repaired in a timely fashion.
1 Check the tire surface and sidewalls for
cuts, cracks, punctures and unusual wear.
2 Check each wheel for damage, bends and
cracks.
To Next Page
Loading...