A-4
Check the Hydraulic Oil Level
Maintaining the hydraulic oil at the proper level
is essential to machine operation. Improper
hydraulic oil levels can damage hydraulic
components. Daily checks allow the inspector
to identify changes in oil level that might
indicate the presence of hydraulic system
problems.
Perform this procedure with
the platform in the stowed position and the
motor off.
1 Remove the hydraulic oil dipstick (fill cap),
wipe it clean and reinstall it.
2 Take the hydraulic oil dipstick out again,
and check the oil level.
3 If the hydraulic oil level is too low and add
new hydraulic oil to the prescribed level.
Hydraulic oil specifications
L-HV46
A-5
Perform Function Tests
Completing the function tests is essential to
safe machine operation. Function tests are
designed to discover any malfunctions before
the machine is put into service. A
malfunctioning machine must never be used. If
malfunctions are discovered, the machine
must be tagged and removed from service.
Complete information to perform this
procedure is available in the appropriate
operator manual. Refer to the Operator
Manual on your machine.
To Next Page
Loading...
Need help?
General
