OPERATOR’S MANUAL with Maintenance Information
Safety Rules
6
Component Damage Hazard
Do not use any battery or charger greater than
48V to charge the battery.
Do not use the machine as a ground for
welding.
Explosion and Fire Hazards
Do not operate the machine in hazardous
locations or locations where potentially
flammable or explosive gases or particles may
be present.
Damaged Machine Hazard
Do not use a damaged or malfunctioning
machine.
Conduct a thorough pre-operation inspection
of the machine and test all functions before
each work shift. Immediately tag and remove
from service a damaged or malfunctioning
machine.
Be sure all maintenance has been performed
as specified in this manual. Be sure all decals
are in place and legible.
Be sure the operator’s manual is complete,
legible and in the storage container located in
the platform.
Bodily Injury Hazard
Always operate the machine in a
well-ventilated area to avoid carbon monoxide
poisoning.
Do not operate the machine with a hydraulic oil
or air leak. An air leak or hydraulic leak can
penetrate and/or burn skin.
Improper contact with components under any
cover will cause serious injury. Only trained
maintenance personnel should access
compartments. Access by the operator is only
advised when performing a pre-operation
inspection. All compartments must remain
closed and secured during operation.
Outrigger Safety
Do not lower the outriggers unless the
machine is on a firm surface. If the ground
does not meet the requirements specified of
the relevant regulations, sufficient ground
preparation shall be carried out in advance to
confirm its safety before operation. Avoid
drop-offs, holes, unstable or slippery surfaces
and other possible hazardous conditions.
In case of special (soft or inclined) ground, the
wood or steel pad suitable for the ground must
be used under the support plate, and it must
be firm and not cave in during the operation.
When using the backing plate, the backing
plate must be of a solid structure that can fully
withstand the pressure of the supporting leg. If
the steel plate is set under the support plate, it
should be used with small deformation.
When the auto level function is not being used
and the outriggers are being lowered
individually, the steer-end outriggers must be
lowered first.
Do not raise the platform unless the machine
is level. Do not set the machine up on a
surface where it cannot be leveled using only
the outriggers.
Do not raise the platform unless all four
outriggers are properly lowered, the footpads
are in firm contact with the ground and the
machine is level.
Do not adjust the outriggers while the platform
is raised.
To Next Page
Loading...
Need help?
General
