DINGLI JCPT1523DC - Page 36

OPERATOR’S MANUAL with Maintenance Information
Operating Instructions
31
The indicator light on the lift function enable
button will turn on when one but not all
outriggers are down. All drive and lift functions
are disabled.
The indicator lights on the lift function enable
button and on the individual outrigger buttons
will turn off when all the outriggers are in firm
contact with the ground.
The drive function is disabled while the
outriggers are down.
To control individual outriggers
1 Push and hold one or more outrigger
function enable buttons.
2 Press and hold the function enable switch.
Activate the proportional control handle in
the direction indicated by the yellow arrow.
The outriggers will extend and level the
machine.
Cannot use the outrigger
directly on uneven surface, soft ground, pit
edges and slopes greater ground, To avoid the
risk of machine tipping, casualties and
equipment damage. If it must be used on the
above ground, be sure to use wood or steel
pad adapt to the ground, and make sure it is
firm.
Outrigger Auxiliary Retract
1 The platform must be in the lowest height.
Operation the machine on the ground
control.
2 Press and hold the lift function enable
button. Press and hold the platform down
button. Press and hold the overload
indicator button.
How to use the Safety Arm
1 Raise the platform approximately 5.5 m
from the ground.
2 Release the safety arm latch, lift the safety
arm and rotate up to a vertical position.
Lock the safety arm in position.
Note: Be sure that the safety arm is locked in
the vertical position.
3 Lower the platform until the safety arm
rests securely on the link.
Crushing hazard. Keep hand
clear of the safety arm when lowering the
platform.
Don’t engage the safety arm
unless unload the platform.
After Each Use
1 Select a safe parking location - firm level
surface, clear of obstructions and traffic.
2 Lower the platform.
3 Turn the key switch to the off position and
remove the key to secure from
unauthorized use.
4 Push in the red Emergency Stop buttons to
“off” position.
5 Push in the main power switch to “off”
position
6 Chock the wheels.