7. Turn up prime valve up to close drain valve,
Trigger gun into flushing pail to purge fluid from
hose, Turn Power OFF.
8. Turn prime valve down to open drain valve,
Unplug sprayer.
9. Remove filters from gun and sprayer, if
installed. Clean and inspect, install filters.
10. If flushing with water, flush again with
mineral spirits, or pump armor, to leave a
protective coating to prevent freezing or
corrosion.
11.If the machine will be storage for over 10 days,
after you cleaned the machine thoroughly,
please take off the suction tube, hose&gun, and
pour about 10ml WHITE lubricating oil into the
fluid pump, Then switch on the machine and let it
keep running (PRIME POSITION) for 5
seconds(once you can see the oil in the prime
tube), This will prevent the wet parts inside being
stuck, corrosive or rusted.
12. Wipe sprayer, hose and gun with a rag
soaked in water or mineral spirits.
To Next Page
Loading...
Need help?
General
