CLEAN UP
As with all spray equipment, your sprayer must be cleaned properly or it will not operate properly.
Clogged are the most common causes of problems. If followed, these guidelines will insure trouble
free performance from your sprayer.
1. Do pressure relief procedure.
Remove siphon tube set from paint and place in
flushing fluid.
Note: Use water for water base paint and mineral spirits
for oil base paint
2. Turn power On, turn prime/spray valve up to
close drain valve.
3. Increase the pressure to about to 1/2
maximum take the trigger safety OFF, trigger
gun until flushing fluid appears.
3. Move the gun to waste pail, hold gun against
pail, trigger gun to throughly flush system,
release trigger and put trigger safety ON.
4. Turn prime valve down to open drain valve
and allow flushing fluid to circulate for 15
seconds to clean drain tube.
5. Raise siphon tube above flushing fluid and
run sprayer for 15 or 30 seconds to drain fluid.
To Next Page
Loading...
Need help?
General
