Dino-Power X24 User Manual

high working pressure will cause
automatic projection.
5.Electronical control board is
broken.
Display error code E3
Description: Pressure sensor is
damaged.
Possible Reason: Inner parts of the
pressure sensor is broken.
Change a new pressure sensor.
Friendly Reminder:
Please thoroughly clean the machine in
time each time after spraying, keep the
inner fluid pump clean, and please store
the machine indoors in winter time.
Display error code E5
Description: Over-heat protection
for the electronical control board
Possible Reason: Over-heat on the
electroncial control board, the most
likely reason is using too small tip
size.
Turn off the power, wait till the electronical
control board cools down, and change
bigger tip size.
Display error code E12
Description: no-load protection
Possible Reason: coatings in the
bucket is empty, the machine will
automatically stop running to protect
the V-packings from fast wear-out.
Turn off the power and then turn on the
power, or turn the pressure regulator to
minimum and then reset the pressure.
Display error code E14
Description: Motor block protection
Possible Reason:
1.Too low voltage and using too
small tip size at the same time.
2.Inner parts of the fluid pump is
damaged.
1.Check the voltage and change bigger tip
size.
2.Check if the inner parts of fluid pump is
damaged, if yes, change the fluid pump.
Display error code E15
Description: Communication error
of the electronical control board.
Possible Reason: Static electricity
interferes the communication inside
the electroncial control board.
Turn off the power, after the display screen
is completely off, turn on the power, if it still
can not solve the problem, then change a
new electronical control board.
Display error code (???u)
Alarm for checking the power
voltage
Possible Reason: When the
voltage is too low or the machine is
not running smoothly, this error
code will occur due to not enough
input power supply.
1.Check the power cable, check if the
patch board is loosened.
2.Change bigger tip size and retry.
3.Turn off the power and adjust the
pressure regulator to minimum, after the
display screen is completely off, turn on the
power supply.
Paint leaks down outside of
pump..
Pump packings are worn
Replace pump packings.

Dino-Power X24 Specifications

General

Brand	Dino-Power
Model	X24
Category	Paint Sprayer
Language	English