Dino-Power X51L User Manual (English)

Questions and Answers:

N
Nathaniel CoxSep 8, 2025
What does error code E4 mean on my Dino-Power X51L Paint Sprayer?
- G
  Gregory BeltranSep 8, 2025
  Error code E4 on your Dino-Power Paint Sprayer indicates: * Too low voltage, too long cable length, or bad contact of the patch board. Check if the voltage reaches 220V, ensure the cable length is appropriate, and verify the patch board is properly connected. * Using too small a tip size. Change to a bigger tip size. * Coatings being too thick. Thin the coatings as per instructions. * The pressure sensor is damaged. Consider changing the pressure sensor or the electronical control board.
L
latoyafosterSep 10, 2025
What does error code E3 mean on Dino-Power Paint Sprayer?
- C
  cassandra63Sep 10, 2025
  Error code E3 on your Dino-Power Paint Sprayer indicates that the inner parts of the pressure sensor are broken. You should change to a new pressure sensor.
A
Anna NavarroSep 12, 2025
What does error code E5 mean on my Dino-Power X51L Paint Sprayer display?
- V
  vvaldezSep 12, 2025
  Error code E5 on your Dino-Power Paint Sprayer indicates over-heating on the electronical control board, most likely due to using too small a tip size. Turn off the power, wait until the electronical control board cools down, and then change to a bigger tip size.
K
Kathleen MorganSep 13, 2025
What does error code E12 mean on my Dino-Power X51L?
- B
  Brittany StoutSep 13, 2025
  Error code E12 on your Dino-Power Paint Sprayer means the coatings in the bucket are empty. The machine automatically stops running to protect the V-packings from fast wear-out. Turn the power off and then on again, or turn the pressure regulator to minimum and then reset the pressure.
H
hernandezpennySep 15, 2025
What does error code E14 mean on my Dino-Power X51L display?
- M
  Michael RodriguezSep 15, 2025
  Error code E14 on your Dino-Power Paint Sprayer indicates too low voltage and using too small a tip size at the same time. Check the voltage and change to a bigger tip size. You should also check if the inner parts of the fluid pump are damaged, and if so, change the fluid pump.