Dionex ICS-6000 - 3.12.2 Manually Pairing the Tablet and Instrument PC

Dionex ICS-6000 Installation Instructions
92
Doc. 22181-97001 02/18
6. Click Close to exit the ICS-6000 App.
7. Restart the app and verify that the message “Connected to <IPC>” is
displayed at the bottom of the log in page.
NOTE
If the message is not displayed, repeat the automatic
pairing procedure or go to Section 3.12.2 to manually
pair the tablet and IPC.
8. If user mode is enabled in Chromeleon, log in to the app, using the
credentials required to log into Chromeleon on the IPC.
NOTE
If user mode is not enabled, login information is hid-
den and the operator is automatically authenticated.
For more information about user mode, refer to the
Chromeleon Help.
3.12.2 Manually Pairing the Tablet and Instrument PC
Perform the manual pairing procedure only if the automatic pairing procedure
(see Section 3.12.1) is not successful.
Tasks Performed from the Instrument PC
1. Obtain the IP address of the instrument PC:
a. On the Windows taskbar, click Start > All Programs > Accessories
> Command Prompt. The command prompt window appears.
b. Type “ipconfig.”
c. Locate the IPv4 Address and write it down.
d. Close the window.
2. Obtain the computer name of the instrument PC:
a. On the Windows taskbar, click Start > Control Panel.
b. Click System and Security.
c. In the right-hand pane, under System, click See the name of this
computer.
d. Under Computer name, domain, and workgroup settings, locate
the Full computer name and write it down.