us.diono.com/installation-videos
1-855-463-4666
60
61
LAP BELT CUSHION COMFORT FEATURES
LAP BELT CUSHION:
For Forward-Facing installations using a LAP BELT
ONLY with NO Top Tether available from 20-65 lbs
(9.1 - 29.5kg). DO NOT use Rear-Facing.
1. Remove the Center buckle pad by pulling it carefully
up and over the buckle.
2. Slide the Center buckle through the slot in the
cushion that matches the slot position being used on
the seat.
3. Reinstall the Center buckle pad. Should you need a
longer buckle, these are available by calling Customer
Service.
ADJUSTING SIDE IMPACT HEADREST:
IMPORTANT: Head support is not recommended for
newborns or small toddlers. When your child fits at
the third harness slot, the head support may now be
used at its lowest position.
1. Carefully unfasten the fabric panels by
detaching the velcro located on the upper sides and
beneath the headrest.
2. Position hand as shown, tilt the top of the headrest
slightly towards you and slide upwards. Note: You
might need two hands.
3. Carefully re-fasten the fabric panels.
4. To lower the headrest, follow the steps above; but
slide the headrest downwards.
To Next Page
Loading...
