19
HOW TO USE
How To Use
DIHG900-E/DIHG450-E
Power Button
Start Button
Control Knob
Display
1. Insert the power plug.
◆ Four lighted dots on the display indicates that the unit is plugged in.
.
2. Operation
◆ If you press the power button, “000C” is displayed.
◆ If you press the Start button, “40C” is displayed, and the unit will
begin heating.
◆ Turn the control knob to adjust the set point from 40℃ to 200℃.
3. To Turn the Unit OFF
◆ Press the Power Button to stop operation and reset the temperature to
40C . Press the Start/Stop button to halt the current operation and retain
the temperature setting.
◆ This unit will run for a maximum of 12 hours. After 12 hours, press
the Start/Stop button to resume heating at the previously set
temperature.
◆ The display will alternate between the set point and the actual
temperature. When the set point is reached, the display will stop
changing.
☞
DIPO is not responsible for damage to the equipment or
injuries caused by mis-use or negligence.
.
To Next Page
Loading...