4
Important Safety Instructions
NOTE: The power supply cord with this air conditioner contains a current detection device designed to
reduce the risk of fire. Please refer to the section “Operation of Current Device” for details. In the event
that the power supply cord is damaged, it cannot be repaired. It must be replaced. Do not use a product
with a damaged power cord. Contact Direct Supply Equipment & Furnishings to order a replacement.
• WARNING: For Your Safety
• Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
• Avoid fire hazard or electric shock. Do not use an extension cord or an adapter plug. Do not remove
any prong from the power cord.
• WARNING: Electrical Information
• Be sure the electrical service is adequate for the model you have chosen. This information can be
found on the serial plate, which is located on the side of the cabinet and behind the grille.
• Be sure the air conditioner is properly grounded. To minimize shock and fire hazards, proper grounding
is important. The power cord is equipped with a three-prong grounding plug for protection against
shock hazards.
• Your air conditioner must be used in a properly grounded wall receptacle. If the wall receptacle you
intend to use is not adequately grounded or protected by a time delay fuse or circuit breaker, have a
qualified electrician install the proper receptacle.
• Ensure the receptacle is accessible after the unit installation.
• Do not run air conditioner without side protective cover in place. This could result in mechanical
damage within the air conditioner. Do not use an extension cord or an adapter plug.
Do not, under any
circumstances, cut,
remove or bypass the
grounding prong.
Power supply cord with
3-prong grounding plug and
current detection device
NOTE: The shape may be different according to its model:
Power Card
Power Supply 230V, 15A 230V, 20A 230V, 30A 265V, 15A 265V, 20A 265V, 30A
To Next Page
Loading...