28
© 2002 directed electronics, inc.
Button I
The door locking and unlocking functions are controlled by
pressing .
Button II
Timer Mode is controlled by .
Button I and II
The remote start function of your system is controlled by
pressing and simultaneously.
ttrraannssmmiitttteerr//rreecceeiivveerr lleeaarrnn rroouuttiinnee
The system comes with one transmitter that has been taught to
the receiver. The receiver can store up to 4 different transmitter
codes in memory. Use the following learn routine to add trans-
mitters to the system or to change button assignments if desired.
The Program switch, plugged into the blue port, is used for
programming. There is a basic sequence of steps to remember
whenever programming this unit: Key, Choose, Transmit and
Release.
1.
KKeeyy..
Turn the ignition to the ON position.
To Next Page
Loading...
