To Next Page

To Previous Page

To disarm the security system,

turn the ignition to the ON posi-

tion. Press and release the Valet

switch within 10 seconds. The

status LED will stop flashing and

the vehicle should start. If the

vehicle does not start, you may

have waited too long; turn the

ignition off and repeat the

process.

Location of Valet Button_________________________________

audible mode

To temporarily turn on the arm or disarm horn honk(s), simply

press for less than one second before arming or disarming,

and the confirmation honk(s) will be present for that one oper-

ation only.

valet mode

You can prevent your system from automatically activating the

Failsafe

Starter Kill (optional, not included) and locking the

doors by using Valet

Mode. This is very useful when washing

the vehicle or having it serviced. In Valet

Mode, the starter kill

cannot be activated, even with the transmitter, but all conve-

nience functions (door locks, trunk release, etc.) will continue to

work normally.

➜

DRW-35

Directed Electronics Valet 712T User Manual

Questions and Answers: