To Next Page

To Previous Page

uussiinngg yyoouurr ssyysstteemm

locking/arming

Pressing for one second arms the system by activating the

starter kill (optional) and locking the doors (if connected). The

horn will honk (if connected and in audible mode) and the

parking lights will flash once to confirm arming of the system.

While the system is armed, the status LED will flash once per

second. The Failsafe

Starter Kill (if installed) will also prevent the

vehicle’s starter from cranking.

The system can also be programmed to arm the optional Failsafe

Starter Kill automatically (called Passive Mode). If the system has

been programmed for Passive Mode, the Failsafe

Starter Kill will

automatically activate 30 seconds after the ignition has been

turned off. After the ignition has been turned off, the status LED

will flash rapidly to indicate that the system is in Passive Mode.

If Passive Mode has been programmed on, then it is also possible

to program the system for Passive Locking. With Passive Locking,

the vehicle doors lock automatically at the same time that the Failsafe

Starter Kill is activated. If Passive Locking is programmed on, care

must be taken to prevent the keys from being locked in the vehicle.

note: For Passive Mode to be effective, the Failsafe®

Starter Kill relay must be installed.

note: Manually locking the vehicle does not arm the sys-

tem; it will only lock the doors.

➜

Directed Electronics Valet 712T User Manual

Questions and Answers: