Feature and Option List
Page 7
* Default Option
Feat. Operation
Flashes/Options Description
1. No RF Output* Module is connected to a remote starter using a standard installation.
2. RFTD Output Module is connected to an XL202 using an RSR or RXT installation (when available).
3. SmartStart Module is connected to SmartStart using an RSR or RXT installation (when available).
1. Driver Priority*
Unlocks only the driver door on first press and unlocks all doors on a second press
within 5 seconds.
2. Unlock All Doors Unlocks all doors on first press.
1. Trunk* Will pop the trunk if available.
2. Right Sliding Door When available, will operate the right sliding door.
2. Left Sliding Door When available, will operate the left sliding door.
1. Trunk Will pop the trunk if available.
2. Right Sliding Door* When available, will operate the right sliding door.
2. Left Sliding Door When available, will operate the left sliding door.
1. Trunk Will pop the trunk if available.
2. Right Sliding Door When available, will operate the right sliding door.
2. Left Sliding Door* When available, will operate the left sliding door.
1. Disabled
The OEM alarm will not be controlled by DBALL upon remote start. No disarm or arm
command will be executed at the beginning or end of the sequence; it must be controlled
by the Remote Starter.
2. Safelock
Smart OEM Alarm Control will behave like a standard Safelock feature on a remote
starter. It will unlock at the beginning of the sequence, and relock after start and
shutdown.
3. Enabled*
Smart OEM Alarm Control will synchronize with the OEM alarm so that it will disarm and
rearm the vehicle in the remote start sequence, only when required. The reason for this
is, factory alarm control must often be done by lock or unlock operation. This could
create unnecessary actions on door lock modules, such as the horn to honk. When
possible, Smart OEM Alarm Control will monitor the alarm and door lock status to detect
if the disarm or rearm is required. If the vehicle is unlocked or is not equipped with factory
alarm, the disarm/rearm will not be executed. Smart OEM Alarm Control will also
monitor the remote starter actions so that the factory alarm control is not done twice. A
remote starter, for which the Safelock feature is active, will work perfectly with this option
and will make it invisible to the user.
RFTD Output Type1
6
Smart OEM Alarm
Control
2 Unlock Driver Priority
3 Trunk
4 AUX1
5 AUX2
It is recommended to configure all the features and options listed below using the configuration tool found on the module
flashing page on www.directechs.com. The web offers more options; however, manual configuration of the features is possible
using the information on this page.
Platform: DBALL/DBALL2
Firmware: GM5 Remote Start Ready (RSR) Installation
© 2015 Directed. All rights reserved.
Rev.: 20150626
Brake Switch 2004-06
3
4
2
1
Brake Switch 2007-10
Brake Sense:
Light Blue, pin 2
OR
Passenger
Kick Panel
4
1
3
2
To Next Page
Loading...
