Directed Electronics Xpresskit Series User Manual

XL202
Installation Guide
COMPATIBILITY
REQUIREMENT SPECIFICATIONS
+
XK Modules
Range Extender*
* Vehicles equipped with factory remote starter only
The RFTD feature of the
CANMAX400 must be turned on to
have full two-way communication.
The power ( ) must be applied
last to the XK module.
12V
†
CANMAX400 is not only a range extender, it is also a standalone remote starter.
TECHNICAL SUPPORT / INFORMATION
web resources:
www.xpresskit.com
www.xpressvip.com
www.directechs.com
tm
Update Alert
Firmware updates are posted to the web on a regular basis. It is important that you check
for firmware and/or install guide updates prior to the installation of this product.
XL202
Remote Starter Standalone
Note: See XpressKit.com for vehicle application guide.
+
XL202
DLPKKICH3
or XK09
†
or CANMAX400
+
XL202
†
CANMAX400
To proceed with the installation of the
XL202 RFTD with Astro firmware you need:
XL202 RFTD module.
D2D harness.
AstroStart RF kit, which includes a
and a receiver antenna.
?
?
? remote
* This image is for example purposes only. Your remote may
be a different model.
*
Page 1
Rev.: 20091124
© 2009 Directed Electronics. All rights reserved.
MODEL: XL202
FIRMWARE: RFTDAF

Directed Electronics Xpresskit Series Specifications

General

Compatibility	Various vehicle makes and models (check specific model compatibility charts)
Function	Extends OEM remote start and security system functionality
Data Protocol	CAN bus and other vehicle data protocols
Firmware	Updatable
Installation	Professional installation recommended
Power Source	Vehicle's electrical system

Summary

Installation Guide

Compatibility

Range Extender Compatibility

Details compatibility with XK Modules and CANMAX400+ for range extension.

Standalone Remote Starter Compatibility

Details compatibility with DLPKKICH3/XK09 or CANMAX400+ for standalone operation.

Requirement Specifications

Update Alert

How to Connect

Connection Diagram and Notes

Illustrates connections for antenna, D2D harness, and vehicle wires with module power notes.

How to Program a Remote

Remote Programming Procedure

Step-by-step instructions for programming remotes into the XL202 module.

Remote Slot Management

Details memory slots, remote order, and potential feature variations.

Switching Between Modes

Mode Selection Process

Step-by-step guide to change the operating mode of the XL202 module.

Mode Identification by LED

Explains LED flash patterns to identify LCD or Non-LCD remote compatibility modes.

Erasing Remote Memory

Remote Memory Reset Procedure

Detailed steps to clear all previously programmed remotes from the XL202.

Limited One-year Consumer Warranty